M/V “NAPA VALLEY” is an eighteen decimal two metre (18.2 m, 59 ft 8 in with platform) pilothouse

motor yacht, production built of fiber reinforced plastic (FRP) by Carver Yachts (Genmar Yacht Group

LLC, Pulaski, WI USA) in year 2007, and currently powered by twin in-line six-cylinder diesel engines

through reversing gears to conventional propellers. The hull is comprised of flared bows with transverse

thruster, single chines, modified “V” underbody, spade rudders, and transom stern with transverse stern

thruster and articulating boarding platform. The interior layout consists of forepeak deck access only

chain locker followed by forward cabin with center-line double berth and starboard side toilet

compartment containing vanity, stall shower, and vacuum toilet, followed by centered passageway aft

accessing port side cabin containing twin stacked single berths, and master cabin aft with island double

berth, toilet compartment, vanity, tub/shower compartment, and clothes washer and dryer units. Next

starboard side spiral staircase up to the pilot house that contains centered helm with pedestal seating

for operator guest lounge, starboard side sliding door casement to side deck, steps up to bridge and

steps down to the salon that contains galley to port, starboard side entertainment centre and sofa with

reclining sections, and sliding door casement to open cockpit. The bridge enclosure consists of canvas

and clear acrylic on stainless steel bows and radar arch that contains centre-line helm and seating

followed by wet bar and and lounge aft. There is also bridge access from cockpit via starboard side

staircase. The cockpit sole contains access hatch to the steering flat/lazarette and bench seating aft.

HOUSE
Exterior Construction
All integral to decks moulded gelcoat FRP trunk and main cabins with bonded glass lenses in FRP and
powder coated aluminum casements, three inclined forward-facing lenses with pantograph type wipers,
clear vinyl/canvas bridge and lounge enclosure
Notes: Clean & serviceable overall
Interior Construction
Moulded FRP liner in toilet compartments and plywood construction cabinetry and paneling sheathed
with bright hardwood and accents, carpeted soles except FRP in toilet compartments, marble
countertops, vinyl deckheads, carpeted soles, moveable furniture, sofa with reclining sections.
Notes: Satisfactory Condition as Observed with little visible wear and tear to note.
Domestic Appliances
One “Euro Kera” Princess three burner A/C countertop, “Tappan” microwave oven, “Sub-Zero” side by
side refrigerator/freezer, “NovaKool” bar fridge, “Malbar” clothes washer and dryer units, “Clarion”
model CMD4, DCZ625, and DSC9205 stereo/tuner, “Solé 32” flat-screen TV, “Sony” 42-inch TV, “KVH”
4HD satellite tracking antenna, “Cruise Air” 72,000-BTU 4-zone reverse cycle air conditioning, “Seaward”
76 litres (20 US gal.) A/C only domestic water heater, 2 X “SeaLand” vacuum toilets, “Jenn-Aire” A/C grill,
Blue-tooth CCTV aft, pressure domestic hot and cold water to galley, washing machine, vanities, toilet
compartment and boarding platform showers, cold only to bridge bar sink and vacuum heads.
Notes: All domestic equipment as sighted appears to be well installed: see Deficiencies for specific

HULL AND DECK
All moulded FRP shoe-box type construction joined at sheer with adhesive sealant and mechanical
fasteners through stainless steel half oval guard, perimeter stainless steel railings, 24-V anchor windlass,
stainless anchor chute and nylon chain roller, hull strike plate, adequate mooring cleats and fairleads,
“GSH” 24-V/hydraulic controlled swim platform.

Rudder: 2 X Cast Bronze Spades Props: 2 X 4-Blade 29” X 32”
Rudder Stocks: Stainless: weeping seals Prop Shafts: 2 X 2 1⁄2-inch “AquaMet”
Packing Gland: 2 X Shaft Seals: see Defic. Trim Tabs: 2 X “Bennett”
Struts: Single Bronze “I” Type per Swim Platform: Articulating “GHS” lift
Transom Door: Sat. as Observed Davit: Swim Platform Function
Stringers: No Deficiencies to Note Bulkheads: 2 Transverse Watertight
Hatches: All Sat. as Observed Windlass: “Maxwell 3500” 24-V
Port Holes: 10 Stainless Ellipsoid in Hull Anchor: ~60 Lb. “Delta” plow
Anchor Rode: Adequate Galvanized Chain Spare Anchor: None Sighted
Mast & Boom: Radar Arch Only 

Machinery
Propulsion is by twin “Volvo-Penta” model D12-D in-line six-cylinder 12.1-litre turbo-diesel engines
through “ZF” model 311A 1.759:1 reduction hydraulic reversing transmissions coupled to 2 1⁄2-inch
diameter “AquaMet” propeller shafts through shaft seals and cast bronze “I” type struts with cutlass
bearings and fitted with outboard turning 29-inch diameter X 32-inch pitch cupped 4-blade “Nibral”
propellers and line cutters. Also fitted is an “Kohler” 22 KW @ 1,800 RPM diesel A/C generator in sound
attenuating cabinet, model 23EOZD, S/N: 2070741, currently inoperable, indicated hours usage not
sighted. Also fitted is “Reverso” lube oil pump for mains and A/C generator.

Serial Nos: P/1012482104,S/...4688 Horsepower: 675 per @ 2,300 RPM
New: 2007 Cooling: Through heat exchangers
Rebuild: No Repair History Sighted Water Filter: Sea Strainers; Serviceable
Oil Filters: Sat. as Observed Air Filters: Factory original type
Packing Glands: Shaft Seals:repair Starboard Controls: “Volvo” single lever servos